Highly conforming polyethylene inlays reduce the in vivo variability of knee joint kinematics after total knee arthroplasty

The use of highly conforming polyethylene inlays in total knee arthroplasty (TKA) provides improved anteroposterior stability.

The aim of this fluoroscopic study was to investigate the in vivo kinematics during unloaded and loaded active extension with a highly conforming inlay and a flat inlay after cruciate retaining (CR) total knee arthroplasty (TKA).

Thirty one patients (50 knees) received a fixed-bearing cruciate retaining total knee arthroplasty (Genesis II, Smith & Nephew, Schenefeld, Germany) for primary knee osteoarthritis. Twenty two of them received a flat polyethylene inlay (PE), nine a deep dished PE and 19 were in the control group (physiological knees). The mean age at the time of surgery was 62 years. Dynamic examination with fluoroscopy was performed to assess the “patella tendon angle” in relation to the knee flexion angle (measure of anteroposterior translation) and the “kinematic index” (measure of reproducibility). Fluoroscopy was performed under active extension and flexion, during unloaded movement, and under full weight bearing, simulated by step climbing.

No significant difference was observed between both types of polyethylene inlay designs and the physiological knee during unloaded movement. Anteroposterior (AP) instability was found during weight-bearing movement. The deep-dish inlay resulted in lower AP translation and a non-physiological rollback.

Neither inlay types could restore physiological kinematics of the knee. Despite the fact that deep dished inlays reduce the AP translation, centralisation of contact pressure results in non-physiological rollback. The influence of kinematic pattern variability on clinical results warrants further investigation.