Finite Element Analysis of Optimal Positioning of Femoral Osteotomy in Total Hip Arthroplasty With Subtrochanteric Shortening
Daisuke Takahashi, MD, PhD,a,∗ Yoshihiro Noyama, PhD,b Tomohiro Shimizu, MD, PhD,a Mohamad Alaa Terkawi, DVM, PhD,a and Norimasa Iwasaki, MD, PhDaHip
Background
Total hip arthroplasty with femoral shortening is frequently recommended for patients with high hip dislocation. However, the possibility of postoperative rotational deviation of the stem presents a challenge for surgeons. We aimed to determine the optimal position for osteotomy in total hip arthroplasty under full weight-bearing and turning torque by using finite element analysis.
Methods
Four models of femoral osteotomy with 30-mm transverse shortening at 30% (model 30), 40% (model 40), 50% (model 50), and 60% (model 60) from the proximal end of the full length of the Exeter stem were constructed. Using finite element analysis, the constructs were first analyzed under an axial load of 1500 N and then with an added torsional load of 10°.
Results
The analyses under torsional loading conditions revealed that the maximum von Mises stress on the stem in each model occurred at the proximal end of the distal fragment and the distal side of the stem. The maximum stress values at the stem were 819 MPa (model 30), 825 MPa (model 40), 916 MPa (model 50), and 944 MPa (model 60). The maximum stress values at the osteotomy site of the medullary cavity side of the distal bone fragment were 761 MPa (model 30), 165 MPa (model 40), 187 MPa (model 50), and 414 MPa (model 60).
Conclusions
The osteotomy level should be around the proximal 40% of the full length of the Exeter stem, which is most suitable for rotation stability in the early postoperative period.
Link to article