The Knee, ISSN: 1873-5800, Vol: 21 Suppl 1, Issue: S1, Page: S3-9

Biomechanics of medial unicondylar in combination with patellofemoral knee arthroplasty

Heyse, Thomas J; El-Zayat, Bilal F; De Corte, Ronny; Scheys, Lennart; Chevalier, Yan; Fuchs-Winkelmann, Susanne; Labey, Luc
Knee

Purpose

Modular bicompartmental knee arthroplasty (BKA) for treatment of medio-patellofemoral osteoarthritis (OA) should allow for close to normal kinematics in comparison with unicondylar knee arthroplasty (UKA) and the native knee. There is so far no data to support this.

Scope

Six fresh frozen full leg cadaver specimens were prepared and mounted in a kinematic rig with six degrees of freedom for the knee joint. Three motion patterns were applied with the native knee and after sequential implantation of medial UKA and patellofemoral joint replacement (PFJ): passive flexion-extension, open chain extension, and squatting. During the loaded motions, quadriceps and hamstrings muscle forces were applied. Infrared cameras continuously recorded the trajectories of marker frames rigidly attached to femur, tibia and patella. Prior computer tomography allowed identification of coordinate frames of the bones. Strains in the collateral ligaments were calculated from insertion site distances.

Results

UKA led to a less adducted and internally rotated tibia and a more strained medial collateral ligament (MCL). Addition of a patellofemoral replacement led to a more posterior position of both femoral condyles, a more dorsally located tibiofemoral contact point and higher MCL strain with squatting.

Conclusion

In comparison to UKA modular BKA leads to a more dorsal tibial contact point, a medial femoral condyle being located more posteriorly, and more MCL strain. Mainly the changes to the trochlear anatomy as introduced by PFJ may account for these differences.

Download article